Axel AX3000 65 User's Manual Uživatelský manuál stáhnout pdf (Strana 97)

Installing under UNIX/LINUX

AX3000 - User's Manual 85

- either a redirection to the ttyp (example: "cat file > /dev/ttyp12")

- or declaring a local printer attached to the ttyp (/dev/ttyp12). This printer

is used through the lp command.

5.3.2 - The LPD Protocol

Set the auxiliary port as shown in Chapter 3.5.2.

Use the appropriate UNIX system management tool to add a remote printer. At

least, two parameters are requested:

- the name of the remote host: enter the AX3000's hostname (refer to

/etc/hosts),

- the name of the printer: this is the Printer Port Name entered when the

AX3000 was set up.

Run the lp command to use this printer.

Note: some options of the lp command (number of copies, banner, etc) cannot

be used, because the AX3000 is not a UNIX server and has no hard disk on

which to run a spooler.

a) Using lpd under IBM AIX V3.x

Enter the SMIT fast path smit mkrque. Four parameters are required:

- Name of Queue to Add:

⇒ name of the printer accessed by the lp command

- Destination Host for Remote Jobs:

⇒ hostname of the AX3000 (refer to /etc/hosts)

- Name of Queue on Remote Printer:

⇒ 'Printer Port Name' associated with the AX3000's port

- Name of Device to Add:

⇒ device name of printer on AIX

b) Using lpd under IBM AIX V4.x

Enter the SMIT fast path smit spooler then select 'Add a Print Queue' and

'Remote'.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 275 276

Žádné komentáře

Axel AX3000 65 User's Manual Uživatelský manuál Strana 97