Axel AX3000 Platine Terminal Ethernet TCP/IP 65E Uživatelská příručka stáhnout pdf (Strana 93)

Remote Administration

________________________________________________________________

TCP/IP AXEL Platine Terminal 91

Note:

rcmd

command is also called

rsh

on some UNIX systems.

Example:

# rcmd axname ax_reboot <CR>

Note: to access an AX3000 with the

rcmd

command, the IP address of the

AX3000 must already be set. The AX3000 IP address can be set:

- through the AX3000 TCP/IP Set-Up, or

- automatically by the RARP protocol (see section2.2.2).

10.2 - SETTING-UP A PLATINE

To set-up an AX3000, use the

rcmd

command together with the

setup_send

keyword. Use a pipe to read data from standard input:

# cat conf_file | rcmd axname setup_send <CR>

Note: the configuration file

conf_file

can be created using a text editor or

obtained using the command '

rcmd setup_get

' (see next chapter). Refer to

section 10.5 for a detailed description of the configuration file.

The message '

Store set-up in progress...

' is displayed on the

operator console when the

rcmd

command is processing. If a connection

problem occurs, a time-out error message is displayed.

When the configuration has been successfully performed, the message '

OK,

set-up updated

' is displayed on the operator console. If other messages are

displayed, refer to Section 10.4.

The AX3000 must read this new Set-Up before it will take effect. This can be

achieved either by power-cycling the AX3000 or by the following

rcmd

command:

# rcmd axname ax_reboot <CR>

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 119 120

Komentáře k této Příručce

Žádné komentáře

Axel AX3000 Platine Terminal Ethernet TCP/IP 65E Uživatelská příručka Strana 93

Komentáře k této Příručce

Související produkty a manuály pro Sítě Axel AX3000 Platine Terminal Ethernet TCP/IP 65E