Axel AX3000 Platine Terminal Ethernet TCP/IP 65E Uživatelský manuál stáhnout pdf (Strana 125)

Installing under UNIX/LINUX

AX3000 - User's Manual 111

is available free on the Axel Web site. See Chapter 8.8.2.

The following rsh commands allow an AX3000 to be controlled over the

network. (On SCO OpenServer the rsh command is called rcmd).

a) Rebooting the AX3000

To reboot an AX3000 over the network, invoke the following command:

# rsh axname ax_reboot password

Where:

- axname : AX3000 name (/etc/hosts) or IP address,

- ax_reboot : command for AX3000 reboot,

- password : specify the set-up password if set.

b) Resetting an AX3000 Resource (screen session or aux. port)

The reset feature allows:

- A network service to be stopped and restarted

- To apply new serial line settings (data transfer rate, handshake, etc.).

The supported resources are:

- Screen sessions: sess1, sess2....

- Auxiliary ports: aux1, aux2, parallel, netX and usbX.

Use the following command to reset a resource:

# rsh axname ax_sinit password ress

Where:

- axname : AX3000 name (/etc/hosts) or IP address,

- ax_sinit : command to reset the resource,

- password : specify the set-up password if set,

- ress : resource name (ex: sess1).

c) Editing the AX3000 Settings

The whole AX3000 set-up can be obtained by invoking the following command:

# rsh axname setup_get > /tmp/axel

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 297 298

Žádné komentáře

Axel AX3000 Platine Terminal Ethernet TCP/IP 65E Uživatelský manuál Strana 125